Filter
Top Products
INSTALLATION
INSTALLATION
Unpack the dishwasher
CAUTION:
Care should be taken when lifting the
machine to prevent damage.
NOTE:
The installation of your machine must meet
all applicable health and safety codes.
1. Immediately after unpacking the machine,
inspect for any shipping damage. If damage is
found, save the packing material and contact
the carrier immediately.
2. Remove the dishwasher from the skid.
Move the machine to its permanent location.
NOTE:
Refer to: To change from Straight-through
Operation to Corner Operation on the next
page if your machine will be placed for
corner operation.
3. Level the machine (if required) by placing a
level on the top of the machine and adjusting
the feet. Level the machine front-to-back and
side-to-side.
4. Remove the dishracks from the interior of
the machine.
5. Refer to Fig. 1. Remove (2) screws that hold
the front panel. Remove the front panel in
preparation for service connections.
Figure 1
Remove Front Panel
!
8
WASH
EXTENDED
WASH
FILL
CYCLE
POWER
WARNING!
TURN OFF POWER BEFORE
SERVICING MACHINE
RINSE