Mr. Coffee CBMPX30 Coffeemaker User Manual


 
7
6
IMPORTANT: RESETTING AUTO BREW AT THE PRE-SET TIME
The programmable timer will not automatically brew the next day if left in the AUTO
position after its last use. This is a safety feature. If the OFF indicator light in the lower
right hand corner of the clock display is illuminated, reset AUTO BREW by turning the
control switch to OFF, then to AUTO.
(Models MPX20, MPX23 Only)
OPERATION AND USE
B
EFORE FIRST USE
Before using your Coffeemaker for the first time, wash decanter/lid and removable inner
brew basket using a mild, non-abrasive detergent and water. Rinse each thoroughly.
Follow Steps 4 – 6 (Brewing Coffee) using water, to clean the inside.
12:00
PM
Off
Hour Min. Brew
On Off Auto
CLOCK D
ISPLAY
HOUR M
INUTE AUTO/OFF INDICATOR BREW
SET SET ON SWITCH LIGHT BUTTON
SETTING CLOCK AND TIMER
(MPX20, MPX23)
NOTE: You do not have to set your clock before the Coffeemaker will operate.
Plug in the power cord, slide the control lever to the ON position. The green
light will illuminate.
SETTING THE CLOCK
1. Turn the AUTO/OFF/ON switch to OFF.
2. Plug the power cord into your electrical outlet. The clock display will flash
until you set the time.
3. Alternately press and hold the HOUR and MINUTE buttons until you reach
the current time. The PM indicator light in the display will illuminate to
indicate PM time.
P
RESETTING THE B
REWING TIME
1. Press and hold the BREW button while setting the desired brew time with the
HOUR and MINUTE buttons. The PM indicator light in the display will
illuminate to indicate PM time.
BREWING AUTOMATICALLY AT THE PRESET TIME
1. Follow Steps 1 – 5 in the BREWING Section.
2. Press the PRESS/HOLD button. The AUTO indicator light should illuminate.
3. Brewing will begin at the preset time. The coffee will remain hot in
the decanter for 2 hours. To keep your coffee hot for an additional 2 hours,
press the SELECT button. The ON indicator light should illuminate.
12:00
Hour Min. Auto Select
PM
+
WARMER TEMP
Auto Start
On
1 4 Cup
Clean
S
ETTING
C
LOCK AND
T
IMER
(MPX30, MPX33, CBMPX30)
N
OTE
: You do not have to set your clock before the Coffeemaker will operate. Plug in
the power cord, press SELECT once to turn the Coffeemaker on. The
ON light
will illuminate and the clock will stop flashing, but it will not keep time.
SETTING THE CLOCK
1. Plug the power cord into your electrical outlet. The clock display will flash
until you set the time.
2. Alternately press and hold the HOUR and MINUTE buttons until you reach the current
time.
3. The PM indicator light in the display will illuminate to indicate PM time.
P
RESETTING THE BREWING TIME
1. You must first set the clock to the correct time before setting the Auto brew.
2. Press the PRESS/HOLD button, then alternately press the HOUR and MINUTE buttons
to set the time you want the Coffeemaker to start brewing. The Auto indicator light
will flash during this time.
3. Press the PRESS/HOLD button again to turn off the flashing light. If the Auto light
is not flashing, pressing the HOUR or MINUTE buttons will change the clock time.
BREWING AUTOMATICALLY AT THE PRESET TIME
1. Follow Steps 1 – 5 in the BREWING Section.
2. Press the PRESS/HOLD button. The AUTO indicator light should illuminate.
3. Brewing will begin at the preset time. The coffee will remain hot in the decanter for
2 hours. To keep your coffee hot for an additional 2 hours, press the SELECT button.
The ON indicator light should illuminate.