Prepare Your Coffeemaker Before First Use
NOTE:To avoid the risk of damage to coffeemaker, do
not plug in your
SPEED
BREW™ coffeemaker until you
complete these steps.
1.Raise the water reservoir lid. (see Figure 1)
2.Turn the brew control dial to “regular”. Using the provided
pitcher, pour one full pitcher of water into the water reservoir
area on top of the
SPEED
BREW ™ coffeemaker. Close
the lid and wait three minutes. (see Figure 2) NOTE: Do
not fill the water reservoir with any liquid other than cold
water (or white household vinegar for cleaning - see
“Routine Cleaning” on page 8)..
3.Place the decanter on the warmer plate. Open the lid. Pour a
second full pitcher of water into the water reservoir. The water
will flow into the internal tank. When the water reservoir is full,
a small amount of water will flow into the decanter. NOTE: To
avoid overfilling the water reservoir, you must wait three
minutes before adding the second pitcher of water.
4. When the flow of water into the decanter stops, empty the
decanter.
5. To flush out the machine for first use, repeat steps 3 and 4
two additional times.
6. Place the empty decanter onto the warmer plate.
7. Now you may plug your
SPEED
BREW™ coffeemaker into
a 120V, AC outlet.
8. Press the Reservoir Power Switch located on the lower
left side of the
SPEED
BREW ™ coffeemaker to ON. (see
Figure 3) Wait at least fifteen minutes for the water in the
internal tank to reach the ideal brewing temperature. Follow
the “Brewing Coffee” instructions on page 7 to brew a perfect
pot of coffee.
IMPORTANT
Before Using Your SPEED
BREW™
Coffeemaker the First Time
Wash decanter,decanter lid and removable brewer basket in mild detergent and water.
Rinse each thoroughly.
6
Figure 1
Figure 2
Figure 3