Filter
Top Products
How To Brew Coffee
1. Depress the latch on top of the brew funnel and remove the
brew funnel from your coffeemaker, see figure #l, on page 6.
place Mr. Coffee
paper
filter inside
Be sure to only use Mr.
Coffee filters. Because of the speed of
this
machine, other paper
filters may cause beverage to overflow the filter during brewing.
2. Place coffee into the filter according to the coffee measurement
chart below.
3. Slide brew funnel back into position until it locks in place.
COFFEE MEASUREMENT CHART
For best results, use level tablespoons (tbls.) of drip grind or grind
recommended for automatic drip coffeemakers.
To brew this much coffee: Use
this
many tablespoons:
10 cups
9 level tbls.
8
cups
7 level tbls.
6
cups
6 level tbls.
4
cups 5 level tbls.
2
cups
3 level tbls.
‘Use
more or less coffee to suit your taste.
2 level
tablesooons
= 1 coffee SCOOP.
4. Fill the decanter with tap water to desired capacity as marked
on the side of the decanter, 1 cup = 5 ounces. To brew 10
cups, fill the decanter to the bottom of the metal band.
5. Lift the dust cover and pour the water through the intake
screen. Place the empty decanter with lid on the warmer plate.
6. Depress the SELECT button twice to set the coffeemaker to
“Brewer On”. The
“Brewer
0n”light
will glow to signal that
the coffeemaker is brewing. Be sure to put the water in the
coffeemaker first, before selecting “Brewer On”. To prevent
damage, the machine will shut off if you have selected “Brewer
On” and there is no water in the machine.
7. The brewing cycle is completed when the “Brewer On” light
goes off and the “Warmer On” light is on.
Note: The adjustable temperature
warmer
plate will keep your
coffee at the temperature you select for up to five hours. For
normal usage, always keep the red dot on the temperature
dial knob within the red temperature range. The setting of
the temperature dial may affect the automatic shut off of The
Expert. If the temperature
setting
is too high, The Expert may
shut off prematurely. If the temperature setting is too low,
The Expert may not shut off when the decanter is removed
from the warmer plate. Refer to the Warmer Plate Temperature
Dial and Intelligent Automatic Shut-Off instructions for further
information.
7