Filter
Top Products
Setting the Clock and Timer (Model PRX20,
only)
IMPORTANT, Please Read Before First Use
l
The clock on this model must be set first, before the coffeemak-
er will operate.
Please refer to setting the clock instructions, below.
indicatorPM
Hour Minute Brew
On/Off
AUTO OFF
Light
Control Switch
indicates Auto Brew needs to be reset On
-
Off
-
Auto
To Set the Clock...
1. Slide the control switch to OFF.
2. Plug the power cord into your electrical outlet. The clock display will
flash until you set the time.
3. Alternately press and hold the HOUR and MINUTE buttons until you
reach the current time. The PM indicator light in the upper left display
corner will illuminate to indicate PM time.
To Pre-Set the Brewing Time...
Press and hold the BREW button while setting the desired brew time
with the HOUR and MINUTE buttons. The PM INDICATOR light will illu-
minate to indicate PM time.
To Automatically Brew at the Pre-Set Time...
1. Follow steps
#l
through
#5
in “BREWING COFFEE”.
2. Always slide the control switch to OFF and then to AUTO.
3. Brewing will begin at the time you have preset and the coffee will remain
hot in the decanter for 2 hours. To keep your coffee hot for an additional
2 hours, slide the switch from AUTO
to ON.
IMPORTANT
To Reset Auto Brew at Pre-Set Time...
The programmable timer will
NOT
automatically brew the next day if
left in the AUTO position after its last use. This is a safety feature. If
the AUTO OFF light in the lower right hand corner of the clock display
is illuminated, reset AUTO BREW by sliding the control switch to OFF
and then to AUTO.
6