Mr. Coffee PR6 Coffeemaker User Manual


 
Automatic Pause
‘n
Serve
For your convenience, our Pause ‘n Serve feature allows you up to 30
SECONDS to sneak a cup while the coffee is still brewing.
-
TO PREVENT INJURY FROM HOT OVERFLOW, REPLACE DECANTER
WITHIN 30 SECONDS IF REMOVED DURING BREWING.
Cleaning Instructions
Your coffeemaker must be cleaned when you begin to notice excessive
steaming or the
brag
time increases considerably. This condition is
caused by a buildup of lime and mineral deposits from your water. If the
pumping action stops before all the water has been pumped out of the
machine, then the appliance requires cleaning.
The frequency of cleaning depends on the hardness of water used. The
following table gives you the suggested cleaning intervals.
SUGGESTED CLEANING INTERVAL
vpe
of Water
Cleaning Frequency
Soft water every 80 brew cycles
Hard water every 40 brew cycles
Your coffeemaker may be cleaned by using MR. COFFEE CLEANER or
vinegar. For best results use MR. COFFEE CLEANER. It is superior to
vinegar and has no unpleasant odor.
Using Mr. Coffee Cleaner
(Read caution statement on side panel of Mr. Coffee Cleaner box before
use)
1.
2.
3.
4.
5.
6.
7.
Fill the decanter to the bottom of the silver band with warm water.
Empty contents of one packet of MR. COFFEE CLEANER into the
decanter and stir until the cleaner is completely dissolved. This will
make a clear blue solution.
Pour the blue solution into the coffeemaker.
Place the empty decanter on the warmer plate. The swing-out basket
with the black filter basket in place should be closed.
Turn your coffeemaker on.
When the blue solution has stopped flowing, turn your coffeemaker
off.
Discard the blue solution and thoroughly rinse the decanter, lid and
black basket.