Filter
Top Products
SETTING THE CLOCK AND DELAY BREW TIME
To Set the Clock:
1. Plug the power cord into a standard
electrical outlet. The clock will flash on
the control panel to indicate that the
time has not been set yet.
2. Press and hold the HOUR and
MINUTE buttons until you reach the
current time. The AM or PM indicator
will light at the bottom of the display
(Figures 1 and 2).
The clock is now set!
NOTE: Pressing any button before setting
the clock will cause the clock to start
keeping time from 6:00 a.m. You must set
the clock if you want to use the Delay
Brew feature.
To Set the Delay Brew Time:
While the display is in the clock mode,
simply press the SET DELAY button
(Figure 3) and, while the DELAY BREW
time is flashing, set the brew time by
pressing the HOUR and MINUTE buttons.
The AM or PM indicator will light at the
bottom of the clock display. (Figure 4)
Within a few seconds the display will
change to the current time.
The Delay Brew Time is now set!
NOTE: To activate the DELAY BREW
cycle, see the “Brewing Coffee Later”
section.
To check the programmed time, push the
SET DELAY button. The display will show
the time you have programmed the coffee
to brew. If you press the SET DELAY
button again or wait a few seconds, the
display will switch back.
9
8
– Delay Brew – Would you like to wake up to a fresh pot of coffee? The timer
allows you to preset when you would like the coffeemaker to automatically begin
brewing your coffee, up to 24 hours in advance.
– Special Cleaning Cycle – Enables you to easily maintain and clean mineral
deposits from your coffeemaker.
NOTE: If you have selected any of the operating functions, the coffeemaker will act upon
the last operation selected if the power is restored within 10 seconds after a power outage.
CLEAN YOUR COFFEEMAKER BEFORE USING THE FIRST TIME
Make sure your first cup of coffee is as good as can be by cleaning your MR. COFFEE
®
Coffeemaker before its first use. Just follow these simple steps:
1. Wash the decanter, decanter lid and the filter basket in a mixture of mild detergent and
water. Rinse each thoroughly (please refer to the parts diagram listed above).
2. Replace all the parts and close the lid. Then, run a brew cycle with water only, without
adding coffee and coffee filter.
3. When brewing is complete, turn your coffeemaker off, discard the water in the decanter
and rinse the decanter, decanter lid, and filter basket.
Your coffeemaker is now ready to use. Enjoy it!
F
IGURE
1
F
IGURE
2
F
IGURE
3
F
IGURE
4
LM SERIES IB-FINAL:Layout 2 10/13/2009 12:05 AM Page 8