Filter
Top Products
MVC-88VGE/VGEW PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #1 (01/11/11) — PAGE 17
1. Place the
fuel valve lever
(Figure 9) in the "ON" position.
Figure 9. Fuel Valve Lever
2. Place the
Engine ON/OFF switch
(Figure 10) in the "ON"
position.
Figure 10. Engine ON/Off Switch
3. Place the
Choke Lever
(Figure 11) in the "OPEN" position.
Nnnn
The CLOSED position of the
choke lever enriches the fuel
mixture for starting a COLD
engine. The OPEN position
provides the correct fuel
mixture for normal operation
after starting, and for restarting
a warm engine.
Figure 11. Choke Lever
4. Place the
throttle lever
(Figure 12) halfway between
fast
and
slow
.
Figure 12. Throttle Lever
5. Grasp the starter grip (Figure 13) and slowly pull it out. The
resistance becomes the hardest at a certain position, corre-
sponding the compression point. Rewind the rope a little from
that point and pull out sharply.
Figure 13. Starter Grip
MVC-88VGE/VGEW— INITIAL START-UP
NOTE
D
CAUTICAUTI
CAUTICAUTI
CAUTION
DO NOT pull the starter rope all the way to the end
DO NOT release the starter rope after pulling. Allow it to
rewind as soon as possible.
D
CAUTICAUTI
CAUTICAUTI
CAUTION
DO NOT attempt to run the compactor until
the Safety and Initial Start-upsectionshave
been read and understood.
FUEL
LEVER
ENGINE
ON/OFF
SWITCH
ON
OFF
Nnnn
OPEN
CLOSED
CHOKE
LEVER
THROTTLE
LEVER
FAST
SLOW
STARTER GRIP