Filter
Top Products
PAGE 14 — MVH-150GH/D — OPERATION AND PARTS MANUAL — REV. #2 (12/04/06)
l
2. The V-belt tension is proper if the V-belt bends 10 to 15 mm
(Figure 9) when depressed with finger at midway between
the clutch and vibration pulley shafts.
Vibrator Oil Check
1. With handle bar positioned vertically (storage position),
remove the breather cap (Figure 6) from the breather plug.
2. Use a 24 mm wrench and remove breather plug (Figure 6).
Visually check to see if hydraulic oil comes up to the oil level
line that is etched on the back side of the handle.
MVH-150GH/D — INSPECTION
OIL LEVEL
CAP
BREATHER
PLUG
HAND PUMP
Figure 6. Vibrator Oil Gauge
2. If the hydraulic oil level is low, replace with "Shell Tellus"
oil #46 or equivalent.
1. To check the V-belt tension (Figure 8 ), remove
upper
belt
cover.
CLUTCH
PULLEY
VIBRATOR
PULLEY
V-Belt Check
CAUTION:
NEVER attempt to check the V-belt with the
engine running. Severe injury can occur of
your hand (Figure 7) gets caught between the
V-belt and the clutch. Always use safety gloves.
Figure 7. V-Belt Hazard
Figure 8. V-Belt Location
3. A loose V-belt will decrease the power transmission output,
causing reduced compaction and premature wear of the
belt.
4. If the V-belt becomes worn or loose, replace it by using V-
belt part number RPF-3350 (Honda engine) or RPF-3340
(Robin engine).
Figure 9. V-Belt Tension