Filter
Top Products
PAGE 18 — MQ-MIKASA MVH-402GHB PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #0 (12/17/03)
MVH-402GHB — OPERATION
1. Grasp the compactor's hand grip and move the engine
throttle lever (Figure 15) quickly to the
fast
position.
2. With the throttle lever in the fast position, the engine speed
should be around 2,300 RPM, therefore engaging the cen-
trifugal clutch.
Figure 15. Throttle Lever ((Fast)
ALWAYS move the throttle lever
quickly without hesitation, because
increasing the engine speed slowly
causes the clutch to slip.
NOTE
3. To make the compactor move in the forward direction push
the travel lever ( Figure 16) forward.
Figure 16. Direction Lever
Traveling
Make sure to follow all safety rules referenced
in the safety section of this manual before
operating compactor. Keep work area clear of
debris and other objects that could cause
damage to the compactor or bodily injury.
CAUTION :
5. Place the
engine ON/OFF switch
(Figure 12) in the "
ON
"
position.
6. Grasp the starter grip (Figure 13) and slowly pull it out. The
resistance becomes the hardest at a certain position, corre-
sponding to the compression point. Pull the starter grip briskly
and smoothly for starting.
7. If the engine has started, slowly return the choke lever
(Figure 14 ) to the
CLOSED
position. If the engine has not
started repeat steps 1 through 6.
Figure 13. Starter Grip
8. Before the compactor is placed into operation, run the engine
for several minutes. Check for fuel leaks, and noises that
would be associated with a loose component.
Figure 14. Choke Lever (Closed)
Make sure to follow all safety rules referenced
in the safety section of this manual before
operating compactor. Keep work area clear of
debris and other objects that could cause
damage to the compactor or bodily injury.
CAUTION :
Figure 12. Engine ON/OFF Switch (ON Position)
4. To make the compactor move in the reverse direction pull the
travel lever ( Figure 16) backwards.
5. Firmly gasp the compactor's hand grip, the compactor will
begin moving in the desired position when the direction lever
has been placed in the desired position.