Filter
Top Products
3
EARTHING INSTRUCTIONS
This appliance must be earthed. In the event of an electrical short circuit, earthing reduces the risk of electric
shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a
earthing wire with a earthing plug. The plug must be plugged into an outlet that is properly installed and earthed.
WARNING : Improper use of the earthing plug can result in a risk of electric shock. Consult a
qualified electrician or serviceman if the earthing instructions are not completely
understood, or if doubt exists as to whether the appliance is properly earthed. If it is
necessary to use an extension cord, use only a 3-wire extension cord that has a 3-
blade earthing plug, and a 3-slot receptacle that will accept the plug on the appliance.
The marked rating of the extension cord should be equal to or greater than the
electrical rating of the appliance.
INSTALLATION
1. Ventilation
Do not block air vents. If they are blocked
during operation, the oven may overheat and
eventually cause a failure. For proper
ventilation, allow 75mm between oven sides
and rear. The minimum free space allowed
from the top surface of the microwave is
100mm.
2. Steady, flat location
This oven should be set on a steady, flat
surface.
This oven is designed for counter top use only.
3. Leave space behind and side
Clearance around all air vents is necessary. If
vents are covered during operation, the oven
may overheat and could cause permanent
damage.
4. Away from radio and TV sets
Poor television reception and radio interference
may result if the oven is located close to a TV,
radio antenna, feeder and so on. Position the
oven as far from them as possible.
5. Position away from heating appliances and
water taps
Position your microwave away from hot air,
steam or splash as the insulation could be
adversely affected and could cause permanent
damage.
6. Power supply
•
Check your local power source. This oven
requires a current of approximately 6 amperes,
240V, 50Hz.
• Power supply cord is about 0.8 meters long.
• The voltage used must be the same as
specified on this oven. Using a higher voltage
may result in a fire or other accident causing
oven damage. Using low voltage will cause
slow cooking. No responsibility will be taken
for damage resulting from use of this oven
with a voltage of ampere fuse other than those
specified.
• If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in order to
avoid a hazard.
7. Examine the oven after unpacking for any
damage
Examine your oven for damage such as:
misaligned door, broken door, a dent in the
cavity. If any of these are visible, DO NOT
INSTALL your microwave and notify your
dealer immediately.
8. Do not operate the oven if it is colder than
room temperature
This can occur if delivery occurs in very cold
weather. Allow the oven to return to room
temperature before operation.