Filter
Top Products
12
12.2 Drawing off cappuccino using the
Professional Cappuccino Frother
Ⅲ To draw off frothed milk, you must activate the steam draw-off
mode first (see Chapter 10 “Drawing off steam”.)
Ⅲ Turn the selector valve (1) (Fig. 8) to area (2) to draw off frothed
milk.
Ⅲ Now draw off frothed milk by turning the hot water / steam
valve to Hot Water / Steam (Fig. 4).
Ⅲ To draw off coffee again, you must activate Coffee Ready mode
first (see Chapter 11 “Returning to Coffee Ready”)
Ⅲ Turn the selector switch (1) (Fig. 8) in horizontal position.
12.3 Cleaning the Professional Cappuccino Frother
Remove the Professional Cappuccino Frother. If you do not
achieve optimum results, disassemble the flow controller and
the selector lever (Fig. 8). Thoroughly rinse these parts with
water
As soon as you have frothed enough milk, it is important to clean
the Professional Cappuccino Frother. Fill water in a jug and
immerse the intake-tube in the water. Now draw off steam until the
water/steam mixture flowing into your cup is completely clean.
Your Professional Cappuccino Frother is clean again.
13. Switching off machine
Ⅲ READY
Ⅲ Use the ON/OFF key to switch off the machine.
14. Adjusting the water quantity for coffee
Ⅲ Use the ON/OFF key to switch on the machine.
Ⅲ MACHINE HEATING
Ⅲ RINSE – PRESS DRAW-OFF KEY
Ⅲ Place a cup under the coffee spout and press one of the draw-off
keys (SMALLCUP or LARGECUP).
Ⅲ RINSING
Ⅲ READY
Ⅲ Press the draw-off key of the product to be programmed
(SMALLCUP or LARGECUP) until the following message is
displayed:
Ⅲ ENOUGH / COFFEE?
Ⅲ As soon as the required quantity of coffee is drawn off, press the
draw-off key again.
Ⅲ READY
15. Programming
You can programme the following stages:
¼ Filter
¼ Water hardness
¼ Steam portion
¼ Water portion
¼ Time
¼ Draw offs
¼ No. of de-scaling operations
¼ Language
15.1 Programming the filter
Refer to Chapter 6 “Installing the Claris plus filter cartridge”.
15.2 Programming the water hardness
Refer to Chapter 5 «Adjusting the water hardness».