Filter
Top Products
USING THE SIDE BURNER
WARNING: IMPORTANT!
USING THE SIDE BURNER:
Inspect the gas supply hose prior to turning the gas
“ON”. If there is evidence of cuts, wear or abrasion,
it must be replaced prior to use. Do not use the side
burner if the odor of gas is present.
WARNING: Always keep your face and body as
far away from the burner as possible when
lighting.
LIGHTING INSTRUCTIONS
To light the side burner, remove any cooking
utensils from the burner grate. Push and turn the
control knob counterclockwise to the “HI” position. If
the burner does not light, turn the control knob to
“OFF”. If the smell of gas is detected and the igniter
is not functioning, immediately turn the control knob
“OFF”. Allow 5 minutes for any accumulated gas to
dissipate. If the side burner igniter is not
functioning, see the following section for match
lighting.
MATCH LIGHTING
Hold a lit extended match or lighter near the side
burner ports, turn the control knob counterclockwise
to “HI”. Move your hand immediately once the
burner is lit. Rotate the control knob to the desired
setting.
CARE & MAINTENANCE
STAINLESS STEEL
The grill is made from stainless steel. There are
many different stainless steel cleaners available.
Always use the mildest cleaning procedure first,
scrubbing in the direction of the grain. To touch up
noticeable scratches in the stainless steel, sand
very lightly with dry 100 grit emery paper in the
direction of the grain. Specks of grease can gather
on the surfaces of the stainless steel and bake on
to the surface and give the appearance of rust. For
removal use an abrasive pad in conjunction with a
stainless steel cleaner.
GRILL RACK
The easiest way to clean the grill is immediately
after cooking is completed and after turning off the
flame. Wear a barbeque mitt to protect your hand
from the heat and steam. Dip a brass bristle
barbeque brush in tap water and scrub the hot grill.
Dip the brush frequently in the bowl of water.
Steam, created as water contacts the hot grill,
assists the cleaning process by softening any food
particles. The food particles will fall and burn. If the
grill is allowed to cool before cleaning, cleaning will
be more difficult.
ENSURE THAT THE GAS SUPPLY AND THE
KNOBS ARE IN THE “OFF” POSITION. MAKE
SURE THE RANGETOP BURNER IS COOL
BEFORE REMOVAL.
GRILL BURNERS
Extreme care should be taken when moving a
burner as it must be correctly centered on the
orifice before any attempt is made to relight the grill.
Frequency of cleaning will depend on how often you
use the grill.
GRILL BURNER CLEANING
Ensure the gas supply is off and the knobs are in
the “OFF” position. Make sure the grill is cool.
Clean the exterior of the burner with a wire brush.
Clear stubborn scale with a metal scraper. Clear
any clogged ports with a straightened paper clip.
Never use a wooden toothpick as it may break off
and clog the port. Please note if insects or other
obstructions are blocking the flow of gas through
the burner, and if so you will need to call our
customer service line.
GREASE TRAY CLEANING:
The grease tray should be emptied and wiped down
periodically and washed in a mild detergent and
warm water solution. A small amount of sand or cat
litter may be placed in bottom of grease tray to
absorb the grease. Check the grease tray
frequently, don’t allow excess grease to accumulate
and overflow out of the grease tray.
17