Filter
Top Products
ENGLISH
8
HELPFUL TIPS
SMOKING
If your HOLLYWOOD KETTLE POPCORN MAKER begins to smoke during
cooking, it may be due to grease build up. In order to reduce smoking,
make sure that you clean the inside of the Kettle between uses.
CLEANING & MAINTENANCE
Make sure appliance is unplugged and completely cooled before cleaning. Unplug 1.
the outer plug to the outlet as well as the Kettle motor plug inside the Main Unit.
Use slightly damp, non-abrasive sponge, towel or cloth to wipe down the 2.
inside and outside of Main Unit, then wipe with a non-abrasive towel to dry.
After Kettle motor has been unplugged and Kettle has completely cooled,
3.
turn Crank Handle clockwise to loosen and remove from Kettle.
Remove Kettle from support brackets. 4.
Take Kettle out of the Main Unit. After removing Kettle from 5.
Main Unit, fill ²⁄
³
of Kettle with hot, soapy water.
Let the Kettle sit for 15 – 20 minutes to cut the grease. (time may vary – use
6.
your own judgment depending on the amount of cleaning necessary)
Empty water. If necessary, use the scrubber side of a 7.
cleaning sponge to scrub inside of Kettle.
Rinse inside carefully and dry.
8.
Wipe outside of Kettle with damp cloth and dry. 9.
Reattach Kettle to Main Unit and then reattach the Crank Handle by inserting 10.
Crank Handle into the Kettle. Turn the Crank Handle counter-clockwise to tighten.
NOTE: To protect the motor plug from getting wet, never immerse the Kettle
in any liquid. Never place any parts in the dishwasher. Always wash by hand.
CHANGING THE BULB
The unit comes with a 20 watt lightbulb installed to make the
Marquee light up. When the bulb goes out, you may change it. Use
a regular lightbulb up to 20 watts or a compact flourescent lightbulb
up to 20 watts for greater light intensity (a compact flourescent
lightbulb is the equivalent of 150 watts with a 20 watt output).
Follow the steps below to change the lightbulb:
While unit is turned off and has cooled completely, unscrew the nine screws 1.
underneath the Marquee using a Phillips head screwdriver. There are three
screws on the front underside of the Marquee, three on the right underside
of the Marquee and three on the left underside of the Marquee.
Lift top of Main Unit to expose the bulb.2.
Unscrew lightbulb and replace with either a regular lightbulb up to 3.
20 watts or a compact flourescent lightbulb up to 20 watts.
Replace top of Main Unit and replace screws.
4.