Filter
Top Products
9
Black pull handle
Connect to the
Beer Line Tube
Connect to
CO2 Gas
Line Tube
Keg Coupler
T
U
R
N
C
L
O
C
K
W
I
S
E
Beer Keg Neck
Keg Support
Beer Keg
Lift Upright
Tapping the Beer Keg (Single-Valve Type Barrel)
Follow these steps below to tap the beer keg.
1. Make sure the black pull handle of the coupler is in the closed (up) position before
installing it on the keg (Fig. 1 - below). Insert the keg coupler into the locking neck of
the beer keg and turn clockwise until it locks into position (Fig. 2 - below). This means
that it is secured to the keg.
2. When connecting the beer line to the top of the coupler, it is very important that the
wingnuttightenscompletely.Thismustbecompletedpriortoinsertingthebackow
stopper into the coupler.
3. Before attaching the CO
2
line, be sure to insert the rubber directional washer into the
side of the coupler.
Attach the CO
2
line(seestep3onpg.5)andhand-tightenrmly.
Secure the tank with CO
2
tank strap.
4. Make sure the beer tower faucet is in
the closed (handle pointing straight
back) position before connecting the
coupler to the keg. To secure the tank
connection, pull the coupler handle
out and push down until it locks into
position. Listen for the “click” of the
pullhandlewhenitshiftsintothenal
downward position (Fig. 4 - below).
This will open the beer and CO
2
gas
valves. The keg is now tapped.
5. Carefully tilt the keg and rest the edge
on the keg base board on the bottom
of the interior cabinet. Slide the beer
keg slowly, ensuring that it is properly
located (Fig. 5) and carefully close the
door.
DANGER!
CO
2
can be dangerous! CO
2
cylinders contain
high-pressured gas, which can be hazardous if handled
improperly. They must be handled with care.
CO
2
Cylinder
Rubber
Washer
CO
2
CO
2
Gas Line
Shut-Off
Valve
CO
2
Regulator
Connect to
CO
2
Cylinder
Rubber
Strap
g. 1 g. 2 g. 3
g. 4 g. 5