Nostalgia Electrics KRS-2000 Series Refrigerator User Manual


  Open as PDF
of 16
 
6
There are three different possible
backowstoppers.
STEP 4
Connect the
CO
2
line from the
regulator to the
coupler.
STEP 1
High pressure washer installed into
CO
2
regulator (may already be installed).
STEP 2
Attach regulator to
CO
2
tank connector.
STEP 3
The
CO
2
rubber
directional
washer goes into
the coupler.
OR
STEP 5
Put one of the
backowstoppers
in the coupler (the
torpedo goes in
with rounded side
down).
OR
Some units may
come with this
attachment. It
is not needed
and should be
removed from the
coupler prior to
STEP 3.
Installing the CO2 Regulator and the CO2 Cylinder
Follow these steps to safely install the CO
2
regulator and CO
2
cylinder. You must read
and understand the following procedures for the CO
2
cylinders before installation.
NOTE: If all your rubber washers & O-rings are not pre-installed, please refer to your parts
list (pg. 6).
NOTE: Your CO
2
cylinder has DOT (USA Department of Transportation) approval,
however the cylinder has been shipped empty to avoid any possible accidents during
transportation.Whenyoupurchasetherstkegofbeer,youmustalsohaveyourCO
2
cylinderlledatyourlocalsupplier.(seepage2,item9forsuggestedlocationswithinyour
community)
 previous next