Filter
Top Products
ENGLISH 3
CLEANSE PRODUCT BEFORE FIRST USE
Detach tank from motor base by sliding the 3
LOCK/UNLOCK switches located on this unit to the
Unlock position. (See Figure A)
Gently remove the tank from the base. Pour warm soapy
water into the tank and dispense all of the soapy water
thought the spigot to clean both tank and spigot. Rinse by
pouring water into the tank and dispense through the spigot
until no soapy residue remains.
A
Once the upper portion has been satisfactorily rinsed out, dry both interior and exterior
sides of the tank thoroughly with a soft non-abrasive clean dry towel.
Replace the upper portion (tank) onto the base, making sure spigot fits properly
In “U” shaped cut out in front of unit.
Slide the 3 LOCK/UNLOCK buttons to the LOCK portion.
USING YOUR MARGARATOR – A QUICK START GUIDE
1. Securely place The MARGARATOR on level surface.
2. The AC plug is located at the base of unit (See illustration
B). Make sure the plug is fitted firmly into the
MARGARATOR™ and the electrical outlet.
3. To operate in the DC power mode, follow all the steps
above except you will use the DC cord that is stored in the
bottom of the unit. (See illustration C) This plug connects to
any 12 Volt power such as the cigarette lighter in your car,
boat or camper, The power switch would need to be flipped
to DC (See illustration E)
B
4. Check the black plastic grinding cage collar inside of unit to
Make sure it is locked in place (See illustration G on page 5).
Fill the unit with ice to the top of the Max Fill Line. (See
illustration D)
5. For Margaritas; Pour 3 Parts concentrated mix (approx. 45
ounces), to 1 part Tequila (Approx. 15 ounces). For a
slushier mix, less liquid is recommended or add more ice
after mixing to achieve the desired consistency.
C
6. Place lid on unit. Line up the arrows (one downward
arrow on the lid and one upward arrow on the tank)
to find the correct fit. (This is a safety lock and the unit
will not turn on without the lid in the correct position).
Lift the handle to a straight up position to lock the unit.
(Illustration A, page 3)
D
7. The lid must be on and the handle must be in the upright
position for the unit to operate. Flip the power switch to AC or
DC (See illustration E). Turn the unit on, begin the slush
process. Blend for about 10 minutes and flip the power
switch to off. If needed, repeat the process to much the
desired consistency.
E