Filter
Top Products
Remove the installation kit from inside the hood.
Make sure that the following items are included:
- Wood strip
- Installation manual
- Accessories including:
• Filters (Quantity varies depending on range hood width)
• Bag of parts including:
(4) flat head screws #10-2’’, (8) screws #8 x
3
⁄4’’, (4) nuts #10-32, (2) wall anchors, (2) washers
3
⁄16’’ ID x
3
⁄4’’ OD
Parts sold separately:
- Interior blower Model RM325H or RM326H (both include rough-in kit)
- In-line blower assembly HLB3, HLB6, HLB9 or HLB11 (all include transition)
- In-line and exterior blower rough-in plate model 332KR, required for all In-line or Exterior Blowers
- Exterior blower assembly 331H, 332H, 335 or 336
- Halogen lights (120 V, 50 W, PAR 20)
- Heat lamps (Infrared, 120 V, BR40, 250 W max.)
- RMP Series Backsplash (optional)
- RBF Series Baffle filters (optional)
- Transitions, duct, elbows, dampers, wall and roof caps.
Refer to pages 4 and 5 for a complete list of venting options
and model numbers.
Using a Phillips #2 or a Robertson #2 screwdriver, unscrew the
hood from the bottom of crate. Refer to figure beside to locate all
4 screws. Discard these screws and remove hood from wood pallet.
- 7 -
3. PREPARE THE INSTALLATION
2. MEASURE INSTALLATION
Dimensions for the most common installation are shown below.
The minimum hood distance above cooktop must not be less than 24’’. A maximum of 30” above cooktop is
highly recommended for best capture of cooking impurities.
Distances over 30” are at the installer and users discretion.
18"
(457 mm)
S
t
a
nd
a
r
d
18
"
(
457
mm
)
H
o
ve
r
-
c
oo
k
t
op
ca
b
i
n
e
t
24"
(610 mm)
Cooktop
19"
(483 mm)
Top of wood
mounting strip
Hood
RMP Series
Backsplash
(optional)
Standard
8 ft. (2.44 m)
ceiling
Standard 36"
(914 mm)
H cooktop
HH0028A
INSTALLATION WITH STANDARD 18’’
HIGH OVER-COOKTOP CABINET
INSTALLATION WITH STANDARD
12’’ SOFFIT OR OPTIONAL
SOFFIT CHIMNEY RMN SERIES
1
2
3
4
HR0002