Filter
Top Products
031666-011 Rev B Page 2 of 11
WATER COOLER
SPECIFICATIONS
Cook and Cold Models
PHT1AQK, PST1AQK
and PHF1AQK (-D100 series)
Voltage 115VAC +10%/1 PH/60 Hertz
Size 43-1/2”(109cm)H., 13-1/2”(34cm)W., 16” (41cm)D.
Shipping Weight (Approx) 60 lbs. (27kg)
Cold Water Capacity* .5 G.P.H. (1.9 L.P.H.)
Compressor 1/20 HP
Compressor (Full Load) 1.1 Amps
Refrigerant R 134a
Refrigerant Charge 1.875 oz. (53 grams)
Hot, Cook, and Cold Models
PHT1AQHK, PST1AQHK
and PHF1AQHK (-D200 series)
Voltage 115VAC +10%/1 PH/60 Hertz
Size 43-1/2”(109cm)H., 13-1/2”(34cm)W., 16” (41cm)D.
Shipping Weight (Approx) 63 lbs. (29kg)
Cold Water Capacity* .4 G.P.H. (1.5 L.P.H.)
Hot Water Capacity 45/6 oz. (45/175ml.) cups
Compressor 1/20 HP
Compressor (Full Load) 5.5 Amps
Refrigerant R 134a
Refrigerant Charge 1.875 oz. (53 grams)
* A.R.I. Ratings: Room Temperature 90°F(32°C); Supply Water Temperature
80°F (27°C); Drinking Water Temperature 50°F(10°C).
Specifications subject to change without notice.
** These units have been manufactured with R134a refrigerant. Repairs to the system must be performed by a
Certified Refrigeration Technician only. Always refer to the data plate located on the base of the unit for the
proper refrigerant and charge.
WARNING:
A pressure regulator, such as a slow flow regulator, must be installed in front of the unit’s
water inlet if the water pressure (including any possible pressure spikes) could exceed 100
P.S.I.G. (690 kPA). Failure to comply will void the warranty. The manufacturer accepts no
liability for damage caused by excessive water pressure.
Do not use this drinking water system where the source water is microbiologically unsafe or with water of
unknown quality without adequate disinfection before or after the unit.