Filter
Top Products
TO ASSEMBLE:
STEP 1 Place the receptacle bin behind the
motor base housing.
STEP 2 Place bowl on motor base housing with the spout
facing the front of the unit with the label and resting in
the middle of the two raised projections.
STEP 3 Place coupling on top of the bowl with the groove
facing upwards and aligned with spout.
STEP 4 Place the strainer basket/blade assembly inside the
bowl, making certain that it rests flat.
STEP 5 Place cover on bowl with ejection chute opening
to the rear. The tab on the front of the cover should rest in
the groove on the coupling. The ejection chute should
rest inside of the receptacle bin.
STEP 6 Place tabs of latch arms over cover and secure by
pressing down on the bottom of each latch arm.
STEP 7 Insert plunger in to the feed chute, with the arrow
facing backwards.
TO DISASSEMBLE:
STEP 1 Remove plunger from feed chute.
STEP 2 Release both side latch arms by inserting fingers
into the two side openings at the bottom of the motor
base housing and pulling outward and upward.
STEP 3 Remove cover.
STEP 4 Lift out bowl, coupling, and strainer basket/blade
assembly together, lifting from the bowl. Do not attempt
to remove the strainer basket/blade assembly by itself.
STEP 5 Separate the strainer basket/blade assembly and
coupling from bowl.
SPECIAL NOTE: The stainless steel basket is a precision-en-
gineered item that should be handled carefully. This will
help the juicer run efficiently and smoothly while increas-
ing its operating life.
4