Filter
Top Products
CLEANING INSTRUCTION
Omega blender container parts are corrosion resistant, sanitary and easily cleaned.
Do not put the container assembly & blender base assembly in the dishwasher.
1.Before first use and after every use, separate container parts from the base.
2.Add cleaning solution to the container. Use washing solution of tepid water (less than
115°F/46°C) and a non-sudsing detergent. Use the recommended amount of detergent.
3.Scrub and flush out the container interior lid and feeder cap to remove food residue. Empty
container.
4.Fill container 1 /4 full with fresh washing solution and place it on the base.
5.Replace the lid on the container and run the blender on high speed for 2 minutes.
6.Repeat step 4 using clean rinse water (95°F/35°C).
7.Wipe down the container, feeder cap, and lid with a soft cloth or sponge, dampened with
fresh washing solution.
8.Wipe the exterior of the base with a damp cloth or sponge. The base contains electrical
components: do not immerse, use a high-pressure washer, or use a dishwasher to clean the
base.
CARING TIPS
To care for your blender, please read the tips as follows:
1.Periodically check all parts before reassembly. As use of damaged or non-recommended
parts could result in a severe personal injury and/or damage to the blender
2.Blades:
If the processing blades are stuck or difficult to turn, DO NOT USE BLENDER (Check by
carefully turning the blades in a counterclockwise direction, where the opposite edges are
sharp. Blades should turn freely.)
3. Container:
If the EASTMAN TRITAN container is cracked, DO NOT USE BLENDER, further use
could result in the container breakage during use.
4. Blender Base:
Never immerse the blender base in water. Unplug unit. The housing can be cleaned with a
damp cloth.
5. Motor:
The motor is permanently lubricated and does not require any additional lubrication.
6. Start / Stop:
When pressing stop do not open the lid and touch the blade, it is dangerous.