Filter
Top Products
MAINTENANCE (REPLACEMENT OF LAMP ) CONTINUED
1. Remove grille. (Squeeze mounting spring and pull
down) (Fig.22 of page 13)
2. Disconnect connector or connector from
lighting unit. (Fig.26)
3. Replace the fluorescent lamp (Panasonic
FHT32E35 32W) or the 4 W night lamp,
connect the connector or connector and
replace the grille. (Fig.27)
PRACTICAL GUIDE TO INSTALLATION
Fig. 26
Plug connector
Plug connector
Receptacle
Receptacle
Fluorescent lamp
4 W Night Lamp
14
4 inches or 6 inches roof jack, wall cap,
or soffit vent with backdraft damper
Mechanically connect duct to termination
and seal with mastic or approved foil
faced tape
2-3 ft straight run before elbow
In attic installation,
caulk box to drywall
Short piece of flexible duct helps
alignment and absorbs sound.
Clamps plus mastic or approved
foil faced tape at all flex joints
Foil tape tightly covers all metal
duct joints (glue PVC joints)
Insulation
Fig. 28
Properly insulate the area around the fan
to minimize building heat loss and gain.
(Fig.28)
Loose fill or batt insulation can be placed
directly over the fan housing in the attic.
Our fans and fan/light combination units
do not create excessive heat that is a
common problem with recessed light
fixtures or some competitors fan/light
combinations. Our efficient, cool-running
motors and our fluorescent lamp do not
create enough ambient heat to be subjected
to these limitations.
'
Fig. 27