Filter
Top Products
User instructions
34
6. Troubleshooting
The dishwasher is equipped with a self-diagnostics system that is capable of
detecting and signalling a number of possible faults
TABLE OF FAULTS DETECTED BY THE SELF-DIAGNOSTICS SYSTEM
FAULT DESCRIPTION
Err01
The anti-flooding system (where present) has been tripped.
Err02
The water level limitation system has tripped.
Err03
The appliance cannot heat the water.
Err04
The temperature sensor is disconnected.
Err05
The appliance cannot take in the water.
Err06
The appliance cannot drain the water from the tank.
Err07
The dishwasher cannot measure the precise water quantity that has
been loaded.
Err08
Problem on the water distribution system to the baskets.
Err09
Water intake system malfunction
If an alarm occurs the appliance interrupts the program in progress and
signals a fault.
• Alarms Err01, Err02, Err03, Err04, Err08 and Err09 interrupt the
current program immediately.
• The Err05, Err06 alarms interrupt the running programme. Once the
cause is resolved, it will continue execution of the programme.
• The alarm Err07 is visualized at the end of the cycle that comes,
however, brought to the end since the operation of the dishwasher is
not harmed.
To “reset” an alarm is necessary:
• Open and close the door, or turn off and on the machine. At this
point is possible to program the dishwasher again.
If the malfunction persists, contact your Panasonic Service Centre.