Filter
Top Products
8 C2237M (1/08)
FULL-SIZE CAMERA MODELS
Figure 3. Wall Mount Installation for Full-Size Camera Models
To install the mount to a wall refer to Figure 3, and then complete the following steps:
1. Pull the wire and cable for the camera through the mounting plate, and then attach the mounting
plate to the mounting surface (hardware not supplied).
2. Attach the 3.25-inch (8.25 cm) tube to the threaded stud on the mounting plate.
3. Attach the ball socket to the threaded stud on the end of the tube.
4. Attach the camera to the 1/4-20 threaded stud on the ball socket, and then tighten the adjustment
ring.
5. Use an 1/8-inch Allen wrench (not provided) to loosen the set screw on the ball socket to position
the camera, and then retighten the set screw.
6. Connect the wires and cable to the back of the camera (refer to the Installation/Operation manual
supplied with the camera for instructions).