Filter
Top Products
4
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.
How To Operate – Flat Top Bottle Coolers
Temperature Control
An adjustable temperature control is located inside
the Bottle Cooler on the evaporator fan panel
assembly. It is factory set at “Normal” approximately
38° F. Make adjustments as shown to attain the
desired temperature.
NOTE: A temperature setting that is too low will not
allow enough condensing unit “off” time to maintain
a frost-free coil.
■
Colder Temperatures: Turn the adjusting
screw clockwise (to the right).
■ Warmer Temperatures: Turn the adjusting
screw counterclockwise (to the left).
■ Temperature Control “OFF”: Turn the
adjusting screw completely counterclock-
wise to the “O” position until a “click” is
noted.
The condenser fan motor turns off and on with
the compressor. The evaporator fan motor runs
continuously.
Cleaning the Condenser:
■ The condenser (located behind the front
grille) should be inspected every 30 days,
and cleaned, if necessary. Failure to keep
the condenser clean will cause a loss in
condensing unit efficiency, or compressor
failure.
Cleaning the Doors:
■ Doors should be periodically removed from the
cabinet and inspected for a buildup of foreign
materials, such as syrups, beer, etc. Buildups
on the underside of the doors, along with the
cabinet breaker strips on which they ride, will
cause them to bind, and therefore, not function
as designed. If dirty, these surfaces should be
cleaned with a mild detergent and water and
then coated with a silicone lubricating material.
Aerosol silicone sprays can be obtained locally
at most department or automotive stores.
To remove doors:
■ With door closed, lift it upward by its handle and
slide forward until door clears the cabinet top.
Use the reverse procedure to reinstall the doors.
Cleaning the Cabinet:
■ Use a damp cloth with a mild detergent and
water to clean the inside and outside of the
cabinet. Dry thoroughly. Do not allow cleaning
agents or large amounts of water to go down
the drain. Use an acceptable stainless steel
polish to clean all stainless steel surfaces.
Never use steel wool or scouring pads to clean
stainless steel.
Avoiding Stainless Steel Corrosion
Corrosion can be prevented by following product cautions, cleaning instructions and avoiding use of certain
chemicals or objects which will cause stainless steel corrosion.
STAINLESS STEEL ENEMY
■ Steel wool or steel scouring pads
■ Cherry/Orange/Olive juice
■ Chlorine Bleach
■ Sharp Objects
Form No. Z2219
Rev. 4.15.06