Filter
Top Products
Form No. Z2060A
Rev. 12.05.03
MODEL NOS. DC2KP DC3KP DC4KP
KEG CAPACITY 2 Keg 3 Keg 4 Keg
DIMENSIONS Length Ins. (mm) 72” (1829) 84” (2134) 96” (2438)
CABINET Depth Ins. (mm) 24
1
/8” (613) 24
1
/8” (613) 24
1
/8” (613)
Height Ins. (mm) 34
1
/2” (876) 34
1
/2” (876) 34
1
/2” (876)
NO. OF DISPENSING HEADS 1 1 2
NO. FAUCETS 2 2 2
CONDENSER UNIT H.P.
1
/4
1
/3
1
/3
RUNNING LOAD - AMPS 5.9 7.5 7.5
SHIP WT lbs. (kg) 445 (202) 505 (229) 545 (247)
INTERIOR Fourteen gauge stainless steel sills are reinforced with a 12 gauge angle bracket that extends from one
end of the insulated base to the other. The floor pan is 20 gauge, type 304 stainless steel. The walls and
ceiling are 20 gauge galvanized steel.
EXTERIOR The top is 20 gauge stainless steel. Bottom is 20 gauge stainless steel. Doors, front, back and sides are
20 gauge black powder coated steel.
STORAGE COMPARTMENTS Side compartment houses a four gallon stainless steel drainer overflow tank, two drain valves with garden
hose fittings for cabinet floor drain and overflow tank, and 20 lb. CO
2
drum holder. Front compartment
provides storage for cups or other non-refrigerated items.
REFRIGERATION R-134a capillary tube-type. Aluminum fin and copper tube evaporator coil. Forced air into dispensing head.
Adjustable temperature control. Self-defrosting. Pull-out condensing unit for service and cleaning.
VENTILATION Front ventilated.
ELECTRICAL 115 Volt, 60 Hz., 1 Phase AC. Furnished with three prong, six foot rubber cord.
Contact Perlick for other voltage/frequency requirements.
PLUMBING None required. Condensate evaporates automatically.
INSULATION Foamed-in-place polyurethane; 2” walls, 1
1
/2” top and floor.
OPTIONAL ACCESSORIES • Optional Dispensing Heads • Shelf Kit • Faucet Locks
• Keg Couplers • Regulators
2
Installation and Operating Instructions
Sizes and Specifications, Concessionaire Dispensers
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.