Philips 47PFL7422 Cooktop User Manual


 
10
TV menu-Install
Notes:
• Immediately after unpacking and plugging in your new television, run the auto store function to set up the TV for the broadcast or
cable channels available in your area. If you do not run the auto store function to set up the channels, your television may not
operate properly.
• After you’ve run Auto store, check out the results. Press P (+) or the P (-) button and see which channels you can select.
• Remember, an antenna or cable TV signal must first be connected to your LCD TV.
Select the menu language
Press the MENU button on the remote control.
Use the cursor down to select Install in the Settings menu.
Use the cursor right to enter the Install menu.
Select Language and enter the list of available languages with the
cursor right.
Select your preferred language with the cursor up/down and press
the OK button to confirm your selection.
Proceed with the Install menu.
Store TV channels
1
2
3
4
5
6
1
2
3
4
5
Press the MENU button on the remote control.
Use the cursor down to select Install in the Settings menu.
Use the cursor right to enter the Install menu.
Press cursor down to select Auto store in the Install menu.
Use the cursor right to enter the Auto store menu and press OK
to start scanning of channels.
Auto storing may take up to 3 minutes to complete. Please wait
until Auto storing is completed . The TV will then switch
automatically to the first channel found.
Auto store
Please wait
Info
Install
Main Controls
Auto store5
Auto store
Manual store
Channel setting
Factory reset
Language
Start ?
Prog. found
0
Frequency 246.50 MHz
Info
Install
Main Controls
Language5 2
中文
English
Auto store
Manual store
Channel setting
Factory reset
Language