General description (fig. 1)
A Power-on button with light
B Mains cord
C Coffee maker
D Water level indicator
E Water tank
F Lid of water tank
G Detachable filter holder
H Lid of thermos jug
I Thermos jug
Introduction
Congratulations on purchasing your new Philips coffee maker. This appliance has been designed for
your convenience and long-lasting enjoyment. The information below will help you use your coffee
maker in the best way to brew delicious coffee. Enjoy!
Important
Read these instructions for use carefully before using the appliance and save them for future reference.
◗ Check if the voltage indicated on the appliance corresponds to the local mains voltage
before you connect the appliance.
◗ Do not use the appliance if the mains cord, the plug or the appliance itself is damaged.
◗ If the mains cord is damaged, it must be replaced by Philips, a service centre authorised by
Philips or similarly qualified persons in order to avoid a hazard.
◗ Do not place the appliance on a hot surface and prevent the mains cord from coming into
contact with hot surfaces.
◗ Keep the appliance and its cord out of the reach of children. Do not let the mains cord hang
over the edge of the table or worktop on which the appliance is standing.
◗ Never immerse the thermos jug in water or any other liquid, as this could cause water to
enter between the walls of the jug.
◗ Never immerse the appliance in water or any other liquid.
◗ Unplug the appliance before cleaning it and if problems occur during brewing.
◗ Do not disassemble the thermos jug.
◗ When the jug is filled with coffee, keep it in upright position to prevent leakage.
Preparing for use
1 Put the appliance on a flat and stable surface.
2 Put the plug in an earthed wall socket.
It is possible that the appliance is switched on (light goes on) when you put the plug in the wall
socket. If this is the case, the appliance cannot be switched off manually but will be switched off
automatically after approximately 30 seconds (light goes out).
◗ You can store excess cord by pushing it into the opening at the back of the coffee maker
(fig. 2).
Prevent the cord from coming into contact with hot surfaces.
Flushing the appliance
1 Fill the water tank half full with water and put the jug in place (fig. 3).
2 Switch the appliance on by pressing the power-on button. The light goes on. Let the
appliance run until the water tank is completely empty (fig. 4).
ENGLISH6