Filter
Top Products
ENGLISH
Introduction
With SENSEO
®
, you can enjoy a perfect cup of
coffee with a delicious crema layer whenever you
feel like it. Each cup is freshly brewed, so you’re
always sure of a pure and round taste. SENSEO
®
combines a unique brewing method from Philips
with convenient coffee pods from Moccona,
available in different blends of ne roast and
ground coffee. Together they make sure you only
get the very best in avour and aroma from the
coffee.
The Moccona coffee in convenient SENSEO
®
coffee pods and Philips’ unique new SENSEO
®
brewing system are perfectly matched to ensure
that the best taste and aroma are extracted from
the coffee.
To optimise the taste of the coffee, keep the
following aspects in mind:
Fresh water
Use fresh water every day. If you have not used the
coffee machine for three days, you have to ush
it with fresh water before you use it again (see
section ‘Flushing’ in chapter ‘Cleaning’).
Fresh coffee pods
Use the SENSEO
®
coffee pods that have
been specially developed by Moccona for your
SENSEO
®
coffee machine for a full, round
taste. Moccona SENSEO
®
coffee pods stay fresh
longer if you close the package with the keep-fresh
seal after use or if you store them in a storage
container.
A clean machine
Clean and descale the Philips SENSEO
®
coffee
machine regularly (see chapters ‘Cleaning’ and
‘Descaling’). Remove used coffee pods after
brewing. If a used pod has been left in the coffee
machine and you have not used the machine for
some time, ush the machine before you use it
again (see section ‘Flushing’ in chapter ‘Cleaning’).
General description (Fig. 1)
A Water reservoir
B Lid of water reservoir
C 1-cup pod holder °
D 2-cup pod holder °°
E Coffee spout
F Cover of coffee spout
G Drip tray
H Cup tray
I Water distribution disc
J Sealing ring
K Outow valve
L Indicator light
Important
Read these instructions for use carefully before
you use the machine and save them for future
reference.
Check if the voltage indicated on the
bottom of the machine corresponds to the
local mains voltage before you connect the
machine.
If the mains cord is damaged, it must
be replaced by Philips, a service centre
authorised by Philips or similarly qualied
persons in order to avoid a hazard.
To prevent unexpected contact with hot
water, always make sure the lid of the
SENSEO
®
machine is properly locked before
you start using the machine.
Never put normal ground coffee or use torn
pods in the SENSEO
®
machine, as this causes
it to become blocked.
,
,
,
,
Do not use the machine in combination with
a transformer, as this could cause hazardous
situations.
Put the machine on a at, stable surface
outside the reach of children. Never let the
machine operate unattended.
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
Do not use the machine at altitudes higher
than 2200 metres above sea level.
The machine does not work at temperatures
below 10°C.
Flush the coffee machine with fresh
water before you use it for the rst time
(see chapter ‘Preparing the machine for use’).
This causes the boiler to ll with water, which
is essential for the machine to work properly.
Electromagnetic elds (EMF)
This Philips appliance complies with all standards
regarding electromagnetic elds (EMF). If handled
properly and in accordance with the instructions in
this instruction manual, the appliance is safe to use
according to scientic evidence available today.
Preparing the machine for use
You cannot brew coffee if you have not ushed
the SENSEO
\
coffee machine rst!
The ushing cycle causes the boiler to ll with
water. After this, the coffee machine is ready for
use.
Flush the machine in the following way:
1 Remove the water reservoir (Fig. 2).
2 Fill the water reservoir with cold water up to
the MAX indication and put it back onto the
machine. (Fig. 3)
3 Move the lever upwards to release the
lid (Fig. 4).
4 Open the lid (Fig. 5).
5 Put the 1-cup pod holder ° or the 2-cup
pod holder °°in the machine without
pod(s). (Fig. 6)
6 Close the lid and lock the lever (Fig. 7).
Note: Make sure you lock the lever properly. Push it
down until it snaps home with a click.
Note: Never ush the machine with the lid open. The
lid must be properly locked.
7 Put the plug in an earthed wall socket.
8 Put a bowl (with a capacity of at least
1500ml) under the coffee spout to collect the
water. (Fig. 8)
9 Press the on/off button I and subsequently
press the 1-cup button
° and the 2-cup
button
°° briey at the same time. (Fig. 9)
The boiler lls itself with water from the
water reservoir. This takes some time (approx.
90 to 150 seconds). The machine switches
off automatically when the ushing cycle
ends. During the ushing cycle, the machine
produces more noise than during a regular
brewing cycle.
Note: Before you use the machine for the rst time,
clean the coffee spout and the pod holders with
hot water and some washing-up liquid or in the
dishwasher. Clean the water reservoir thoroughly in
hot water, if necessary with some washing-up liquid.
,
,
,
,
,
,
,
,
Now your Philips SENSEO
®
coffee machine is
ready for use.
Brewing coffee
1 Fill the water reservoir with cold water up to
the MAX indication and put it back onto the
machine. (Fig. 3)
Never pour milk, coffee, hot water or carbonated
water into the water reservoir.
° MIN: minimum amount of water required
to brew 1 cup of SENSEO
®
coffee.
°° MIN: minimum amount of water
required to brew 2 cups of SENSEO
®
coffee.
A full reservoir allows you to make SENSEO
®
coffee a number of times (up to 5 cups). This
makes it unnecessary to ll the water reservoir
each time you want to make a cup of coffee.
2 Press the on/off button I. (Fig. 10)
The indicator light blinks while the water is heating
up. Heating up takes approx. 90 seconds.
The coffee machine is ready for use when the
indicator light burns continuously.
3 Move the lever upwards to release the
lid (Fig. 11).
4 Open the lid.
5 Place the appropriate pod holder in the
machine.
Note: Make sure the pod holder is clean and the
sieve in the centre is not clogged, e.g. with loose coffee
grounds.
If you want to make one cup of SENSEO
®
coffee, use 1 coffee pod in combination with
the 1-cup pod holder ° and the 1-cup
button °. (Fig. 12)
If you want to make two cups of SENSEO
®
coffee, use 2 coffee pods in combination with
the deeper 2-cup pod holder °° and the
2-cup button
°°. (Fig. 13)
6 Place the SENSEO
®
coffee pod(s) properly in
the centre of the pod holder, with the convex
side pointing downwards.
Note: Use SENSEO
®
coffee pods from Moccona
specially designed for your SENSEO
®
coffee machine
for a full and round taste.
Place 1 SENSEO
®
coffee pod in the 1-cup
pod holder °. (Fig. 14)
Place 2 SENSEO
®
coffee pods in the 2-cup
pod holder °°. (Fig. 15)
Note: Make sure the coffee in the pod(s) is evenly
distributed and press the pod(s) lightly into the pod
holder.
Note: Never put normal ground coffee or use torn
pods in the SENSEO
®
machine, as this causes it to
become blocked.
7 Close the lid and lock the lever (Fig. 7).
Always make sure the lid is properly locked. Push
the lever down until it snaps home with a click.
Never start brewing with the lid open. The lid
must be properly closed.
8 Place one cup or two cups under the spout
openings (Fig. 16).
The cups you use should have a capacity of at
least 150ml. Do not use cups that are too large, as
they cause the coffee to get cold more quickly.
9 Press the button that indicates the number
of cups of SENSEO
®
coffee you want to
brew. (Fig. 17)
° for one cup
°° for two cups
The SENSEO
®
coffee machine starts brewing.
The machine automatically supplies the optimal
amount of water.
-
-
-
,
,
,
,
,
-
-
,
-
422200197772
3/6