Filter
Top Products
OPERATION
L20-258-UK Rev.01 8/16/04 7
FILTERING INSTRUCTIONS (continued)
e. Ensure that flush hose is pointed into tank and place Filter ON/OFF ( I/O ) switch in the ON
( I ) position. The pump will begin to return shortening/oil to the tank.
WARNING
For your safety, NEVER allow flush hose nozzle to point away from the tank while
filtering.
f. Carefully rinse the tank back and sides with stream of returning shortening/oil. You can use
the cleaning brush and cleaning rod to aid in removing debris from the tank.
g. Once all debris has been rinsed from the tank, close the drain valve and allow the tank to
refill. To ensure that filter lines are purged, allow the filter to run for 15 seconds after all
shortening is returned to the tank. Additionally, it may be necessary to add a small amount
of shortening/oil to bring the shortening/oil back to the OIL LEVEL line.
h. It may be necessary to repeat steps d through h if shortening/oil quality is not acceptable.
Otherwise, you may now turn the appliance on per the instructions in this manual and
resume operation.
To ensure proper operation and sanitary conditions, the filter system should be disassembled and
cleaned with hot water and mild detergent daily. Refer to the CLEANING AND MAINTENANCE section
of this manual for instructions.
FILTER PAPER REPLACEMENT
For models with filter option refer to the following instructions
a. Detach the pickup tube from the filter pickup assembly by unscrewing it (counterclockwise), at the
knurled fitting, from the threaded fitting on the filter screen.
b. Slide off the filter paper clip and remove used filter paper from filter screen. Replace with new filter
paper, ensuring that the hole in the paper is on the top, so that threaded fitting in filter screen
protrudes through it.
c. Fold filter paper to the underside of the filter screen and replace filter paper clip.
d. Re-attach filter pickup tube to the filter screen by screwing it (clockwise) into the threaded fitting in
filter screen.
e. Reinstall the filter pickup assembly into the filter system by placing the newly covered screen
portion of the assembly into the filter pan and connecting the quick disconnect on the filter pickup
assembly into white donut fitting on the left-hand side of the appliance. Ensure that it snaps tightly
and securely into donut fitting.
You are now ready to filter the shortening/oil in your appliance. Refer to the FILTERING INSTRUCTIONS
section of this manual for instructions.