Filter
Top Products
INSTALLATION & START-UP
Location
For proper operation and maximum performance, locate the Crisp n’
Hold in an ambient air temperature of 70º F (21ºC).
Avoid areas near exhaust fans where there is active air movement.
For safe operation, locate the unit a reasonable distance from com-
bustible walls and materials.
To prevent injury and damage, locate the unit at a proper and safe
working height.
The location should be level, clean of debris, and
strong enough to support the weight of a fully loaded unit.
Start-up
1
.
Plug the Crisp n’ Hold into a properly grounded electrical recep-
tacle.
2
.
Ensure all plastic and packaging materials have been removed.
3
. Familiarize yourself with the controls.
4
. On/Off switch is located inside the cabinet below the product
station. Set POWER switch to “ON” position.
5
. Do not load product into the cabinet. Allow the heat to remove
any residual oils which may adhere to inside metal surfaces.
A
slight emission of smoke is normal for the first few hours of
operation.
GROUNDING INSTRUCTIONS
This appliance is equipped with a cord having a grounding
wire with a grounding plug which must be plugged into an
outlet that is properly installed and grounded.
In the event of
an electrical short circuit, grounding reduces the risk of elec-
tric shock by providing an escape wire for the electric current.
WARNING—Improper use of the grounding can result in
a risk of electric shock. Consult a qualified electrician or
serviceman if the grounding instructions are not completely
understood, or if doubt exists as to whether the appliance is
properly grounded.
5
WARNING:
Risk of personal injury
Installation procedures must be
performed by a qualified technician
with full knowledge of all applicable
electrical codes.
Failure can result in personal injury
and property damage.
IMPORTANT:
Power cord is 7' long.
If necessary, contact a licensed
electrician to install an appropriate
20 amp electrical circuit with correct
NEMA receptacle.
CAUTION:
Electrical Shock Hazard
The ground prong of the power cord
is part of a system designed to pro-
tect you from electric shock in the
event of internal damage.
DO NOT cut off the large round
ground prong or twist a blade to fit
an existing receptacle.
IMPORTANT:
Not under warranty:
Damage to unit due to being
connected to the wrong voltage or
phase is NOT
covered by warranty.
CAUTION:
Risk of personal injury
Unit is not waterproof, to avoid
electrical shock keep unit and
counter from being submerged in
water
. Do not operate if unit has
been submerged in water.