Filter
Top Products
L80-045 Rev0 (11/07)
10
14. Apply the new manual fill option overlay (A6066901) to the new manual
fill option bezel (B3615401-C). With a 3/8” wrench, remove the four kep
nuts that hold the controller to the original bezel and install it onto the
new bezel using the original hardware.
15. Reconnect the controller plug and mount the bezel using the original
hardware. Install the fill knob and tighten the set screw. Make sure the
knob only travels within the markings of the overlay.
16. If a water source is available, hook it up and inspect all connection points
for leaks. If a water source is not available fill the tank with water and
inspect all connection points below the water line.