Filter
Top Products
L80-045 Rev0 (11/07)
6
4. Apply Teflon tape to the 90° compression fitting (PP10911) and install.
Make sure the fitting is at the 3 o’clock position when fully tightened.
5. Apply the compression fitting (PP10830) to the front end of the fill
piping (A8017501) before install. Apply the remaining two 90°
compression fitting (PP10911) to each end of the supply piping
(A8017401). After each end is compressed remove the body of the fitting
6. Install the fill piping from the rear of the unit. The piping should sit on
top of the left tank support. Insert the rear end of the piping in to the rear
compression fitting and tighten the fitting.