Filter
Top Products
Exploded Parts-VF35 Gas Model
L22-382 Rev 1 (08/14)
TO THE PURCHASER, OWNER AND
STORE MANAGER
Please review these warnings prior to
posting them in a prominent location for
reference
Post in a prominent location the instructions to be
followed in the event that an operator smells gas.
Obtain this information from your local gas supplier.
WARNING
DO NOT store or use gasoline or other flammable vapors and liquids
in the vicinity of this or any other appliance.
WARNING
Improper installation, alteration, service or maintenance can cause
property damage, injury or death. Read the installation, operating and
maintenance instructions thoroughly before installing or servicing this
appliance.
WARNING
Installation, maintenance and repairs should be performed by a Pitco
Authorized Service and Parts (ASAP) company technician or other
qualified personnel. Installation, maintenance or repairs by an
unauthorized and unqualified personnel will void the warranty.
WARNING
Installation and all connections must be made according to local codes
in force. In the absence of local codes in North America, the installation
must conform with the National Fuel Gas Code, ANSI Z223.1/NFPA 54 or
the Natural Gas and Propane Installation Code CSA B149.1 as
applicable. In Australia, the appliance must be installed in compliance
with AS/NZS 5601.
WARNING
During the warranty period if a customer elects to use a non-original part
or modifies an original part purchased from Pitco and/or its Authorized
Service and Parts (ASAP) companies, this warranty will be void. In
addition, Pitco and its affiliates will not be liable for any claims, damages
or expenses incurred by the customer which arises directly or indirectly,
in whole or in part, due to the installation of any modified part and/or
received from an unauthorized service center.
WARNING
This appliance, when installed, must be electrically grounded in
accordance with local codes, or in the absence of local codes, with the
National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code,
CSA C22.2, as applicable
WARNING
Adequate means must be provided to LIMIT the movement or this
appliance without depending on the gas or electrical cord connection.
Single appliances equipped with legs must be stabilized by installing
anchor straps. All appliances equipped with casters must be stabilized by
installing restraining chains.
WARNING
DO NOT alter or remove structural material on the appliance to
accommodate placement under a ventilation hood.
WARNING
If the appliance is equipped with a power cord and it is damaged, it must
be replaced by a Pitco Authorized Service and Parts (ASAP) company
technician, or a similarly qualified person in order to avoid a hazard.
WARNING
The power supply must be disconnected before servicing, maintaining or
cleaning this appliance.
WARNING
The appliance is NOT jet stream approved. DO NOT clean the appliance
with a water jet.
WARNING
DO NOT attempt to move this appliance or transfer hot liquids from one
container to another when the unit is at operating temperature or filled
with hot liquids. Serious personal injury could result if skin comes in
contact with the hot surfaces or liquids.
WARNING
DO NOT use an open flame to check for gas leaks!
WARNING
DO NOT sit or stand on this appliance. The appliance’s front panel, tank,
splash back, tank cover, work shelf, drain board is not a step. Serious
injury could result from slipping, falling or contact with hot liquids.
WARNING
NEVER use the appliance as a step for cleaning or accessing the
ventilation hood. Serious injury could result from slips, trips or from
contacting hot liquids.
WARNING
The oil/shortening level should NOT fall below the minimum indicated level
line at any time. The use of old shortening can be dangerous as it will
have a reduced flash point and be more prone to surge boiling.
WARNING
The contents of the crumb catch and/or filter pan of any filter system must
be emptied into a fireproof container at the end of the frying operation
each day. Some food particles can spontaneously combust into flames if
left soaking in certain oil/shortening materials.
WARNING
Completely shut the appliance down when shortening/oil is being drained
from the appliance. This will prevent the appliance from heating up during
the draining and filling process. Serious injury can occur.
WARNING
This appliance is intended for indoor use only.
WARNING
DO NOT operate appliance unless all panels and access covers are
attached correctly.
WARNING
It is recommended that this appliance be inspected by a qualified service
technician for proper performance and operation on a yearly basis.
WARNING
There is an open flame inside this appliance. The unit may get hot enough
to set nearby materials on fire. Keep the area around the appliance free
from combustibles.
WARNING
DO NOT supply the appliance with a gas that is not indicated on the data
plate. If you need to convert the appliance to another type of fuel, contact
your dealer.
WARNING
If gas flow to appliance is interrupted, or pilots extinguish, wait 5 minutes
before attempting to relight the pilot to allow any residual gas in appliance
to dissipate.
WARNING
Ensure that the appliance can get enough air to keep the flame burning
correctly. If the flame is starved for air, it can give off a dangerous carbon
monoxide gas. Carbon monoxide is a clear odorless gas that can cause
suffocation.
WARNING
Never add oil to the appliance when it is at operating temperature.
Splashing hot oil can cause severe injuries.
WARNING
Never add water to hot oil. Violent boiling can occur causing severe
injury.
WARNING
This appliance is intended for professional use only and should be
operated by fully trained and qualified personnel.
WARNING
To avoid splashing of hot liquid when installed, this fryer must be
restrained either by the manner of installation, or with adequate ties to
prevent tipping.
WARNING
An appliance equipped with casters and a flexible gas line must be
connected to the gas supply with a quick disconnect device. In North
America, gas appliances equipped with casters must be installed with
connectors that comply with the Standard for Connectors for Movable Gas
Appliances, ANSI Z21.69.CSA 6.16 Latest Edition. This connection should
include a quick disconnect device that complies with the Standard for Quick
Disconnect Devices for Use With Gas Fuel ANSI Z221.41.CSA 6.9 Latest
Edition. In Australia, an appliance equipped with casters and a flexible gas
line must be connected to the gas supply with a quick disconnect device that
complies with AS 4627. The hose must comply with AS/NZS 1869 and be
class B or D and have a restraining cable. The restraining cable must not
exceed 80% of the length of the flexible gas line.