Filter
Top Products
4
CLEANING
DAILY
1 Teflon sheets should be rotated and cleaned on a
daily basis. NOTE: Do not use sharp objects to
clean Teflon sheets.
2. Wipe conveyor belt with a damp cloth on a daily
basis. Remove front cover/bun chute assembly to
access the conveyor belt. NOTE: Do not use sharp
objects to clean the conveyor belt.
MONTHLY
1. Conveyor belt should be removed and cleaned
thoroughly on a monthly basis.
2. Remove front cover/Bun Chute Assembly by pulling
up and off of the toaster and set aside.
3. Loosen thumbscrews and remove left side panel.
4. Press down on conveyor belt upper roller and lock
into position.
5. Release upper and lower locking latches from the
conveyor rollers.
6. Remove conveyor belt from the unit. It is easier to
remove the belt by turning it as you pull it from the
side.
6. Place belt on a flat surface, being careful not to
crease the loops.
7. Clean with hot soapy water and sponge, then let air
dry.
8. Reverse steps 2-5 to replace conveyor belt.
CONVEYOR BELT TRACKING ADJUSTMENT
The Conveyor belt tracking adjustment allows for
adjusting the conveyor belt if it slides too far to either
side of the conveyor. Adjustment screw is located on
the left side of the unit by the upper locking latch.
1. If the conveyor belt slides too far to the right, loosen
the nut, then turn the adjustment screw clockwise
to tighen, this will move the belt back to the center.
Tighten the nut to lock the adjustment screw into
place.
2. If the conveyor belt slides too far to the left, loosen
the nut, then turn the adjustment screw counter
clockwise to loosen, this will move the belt back to
the center. Tighten the nut to lock the adjustment
screw into place.