Filter
Top Products
8
the light source mounting flange align properly with the two tapped holes along the upper
edge of the adapter plate.
9.
Insert the (2) 8-32 x ½” cap screws from the plastic bag in the inner pair of clearance
holes in the light source mounting flange and tighten.
10. Replace the light source cover.
The FA-448 Filter Assembly and Modified Light Source are now ready for use. Refer to the
filter assembly and the light source instructions for operation.
Operation : (All Serial Numbers)
For operation, connect the cable between the lamp housing and power supply, then plug in the
power supply. Press the power on/off button on the front of the power supply and adjust
brightness to desired level. To shut off the light source, press the power on/off button.
Note:
The light source may be turned on or off at any of the brightness settings without
damage to the lamp.