Filter
Top Products
Troubleshooting Guide
Replacement Parts for Model HBH450
Problem . . . Solution . . .
Blender fails to start
or stops while it is
running and cannot
be restarted
• Check to see if unit is securely plugged into an electric outlet.
• Check to see if the integrated circuit breaker has tripped and reset it, if needed.
• Check to see if the fuse for the electric outlet has blown or if a circuit breaker
has tripped.
Maintenance
Unplug the blender and remove the container from the base, and then inspect the
container and cutter unit assembly for wear, nicks, and broken or loose blades. Replace if
necessary. If the blades are loose, discontinue use immediately and replace the blades.
Do not attempt to repair or tighten the cutter assembly. See “Replacement Parts” below.
Unplug the blender, and then inspect the power cord insulation and power plug for cracks.
Refer to “Technical Service” for repair or replacement.
Replace the container and cutter assembly at least every 90 days. See “Replacement
Parts” below.
48 oz. polycarbonate container 6126-450
Cutter assembly 98450
Part Description
Part Number
Inspect the blender and its various parts and replace as follows:
Daily
Weekly
Quarterly
Ingredients will not mix
properly
• Check to see if enough liquid has been added to the ingredients. Mixture should
be fluid and free-running at all times.
• Solid pieces are too large. Pieces should not exceed 1" cubes.
• Container is too full. Do not fill past highest graduation marking.
• Cutter unit blades are not sharp or are damaged. Inspect container and cutter
assembly daily. Replace cutter assembly at least every 90 days or sooner if cutter
assembly appears worn or damaged.
• Check to see if cutter assembly is installed properly.
• Select speed to create a fluid blend.
For replacement parts, call toll free: 866-285-1087.
Caring for the Blender
9