Filter
Top Products
17
1
Fitting the adjustable feet
Unpack the support brackets with the feet
attached. Place a piece of cloth/cardboard onto
your floor to prtect both your floor and the cooker.
Lay the cooker on its back, fit the support
brackets (see fig) using the bolts, washers and
nuts supplied and ensure that the nuts are tight.
lift the cooker upright onto its feet.
Levelling the cooker and fitting the plinth
• Unscrew the legs as far as possible (approx.
16mm from fully screwed in).
• Place the plinth (pos.3) so that the springs
(pos.2) reach the threaded area of the legs
and the clamp of the plinth (pos.4) is in front
of the holes (pos.5) on the under side of the
structure.
• Push the plinth towards the appliance with
both hands until the springs fasten on the legs
and the clamps go into the corresponding
holes.
• Adjust the legs as necessary.
1
3
2
5
4
GAS CONNECTIONS
Note: It is recommended that the gas
connection to the cooker is installed with a
flexible tube made to BS5386.
CONVERSION TO LP GAS
Your cooker is designed to work with natural
gas, propane or butane.
To purchase a LPG conversion kit speak to the
Retail Store from where you purchased the
product.
The conversion must only be carried out by a
corgi registered engineer and when cjhanging
injectors to a different type of gas supply the
instructions on adjustment and installation on
the particular category of gas supply must be
observed. After the conversion always carry out
the gas leak test, seal any adjustment or
preadjustment parts and affix a label to the
appliance in place of the old one, relative to the
new gas adjustment.
Stick the label supplied with the
appliance (in the nozzles bag) corresponding
to the gas type utilised.