Proline PLZIGL1 Ventilation Hood User Manual


 
User manUal | 13
step 4
step 5
step 6
island hood installation
Install Chimney
slide inner chimney sleeve over support brackets,
covering the ceiling bracket
screw into place at the top of ceiling bracket
slide outer chimney sleeve to the bottom portion
of the chimney
adjust until the bottom chimney sleeve comes a
few inches from the bottom of the support brack-
ets
you may want to use painters tape to help hold
the chimney in place while you proceed to step 5
Attach Hood
if your hood comes with a transition ducting piece,
secure it to the base of your hood before mount-
ing
place the base of the hood directly under the
chimney
screw hood to the support brackets on all 4 cor-
ners
feed electrical and ducting work through chimney
slide outer chimney sleeve down into place, meet-
ing the top of the hood
*first make sure your ductwork and electrical work are pulled through the ceiling and ready to go
(see preparation work and step 2 above)
Install Filters
if your hood will be ductless, install the charcoal
filter (see filter information after the Control Panel
diagram above)
peel off any protective tape or film on the metal
filter
pop the spring loaded metal filter into place, di-
rectly under the hood
That’s it! Now you’re ready to enjoy your new
island hood!