Filter
Top Products
4
Key Features
Note: Refer to the Unpacking and Parts section on page 2 for the location of key features.
POWER SWITCH
• The power switch is located on the back of the unit and is black. This switch shuts off
electricity to the entire cooler.
WATER DISPENSING
• Simply dispense the button with the blue waves for cold water and the button with grey
waves for room temperature water.
• To help prevent burns, the hot temperature button (marked with red waves) is equipped
with a child safety lock. To dispense hot water, slide the safety lock to the left and then
push the hot water dispensing button.
• Dispensing water is easy — simply place a glass in the center of the drip tray and push in
the appropriate push button.
• DANGER: DO NOT ALLOW CHILDREN TO USE THE HOT WATER DISPENSING BUTTON
WITHOUT PROPER AND DIRECT SUPERVISION.
HOT WATER TANK POWER SWITCH
• As an additional safety feature, your unit is equipped with a hot water tank power switch
should you choose to shut off the hot water heater function, while continuing to use the
cold and room temperature cooler functions. The hot water tank power switch is located
on the back of the unit and is red.
REMOVABLE DRIP TRAY
• To remove drip-tray for draining, lift the tray up and drain water into the sink. Hand-
wash drip tray by removing the grille from the drip tray, and then washing components
with mild soapy water. Do not put the drip tray in the dish washer. To replace the drip
tray, push the tray down into the drip tray area until securely in place.
NIGHT LIGHT
• Your unit is equipped with a special night light feature for nighttime safety. To turn the
nightlight on or off while continuing to provide power to the cooler, use the green switch
on the back of the unit.
HEATING AND COOLING LIGHTS
• Heating and Cooling Lights indicate when the water is not ready
to dispense. A red light
will shut off when hot water is ready and a blue light will shut off when the cold water
is ready to dispense.
COLD KNOB
• You can regulate the cold temperature of your water by adjusting the knob on the back
of the unit. Turn the knob to any setting between min. and max. to suit your temperature
preference.
How to Monitor Filter Life
How to Monitor Filter Life / Filter Life Indicator (Figures 10 - 12)
BEGINNING OF LIFE:
• The orange dot starts at the O position. (See figure 10)
DURING USE:
• As the water runs through the filter, the orange dot will
move clockwise around the monitor pathway.
(See figure 11)
• It is important that the cooler fill tank be filled
completely and emptied completely each time it is used.
END OF LIFE:
• The filter is full when the orange dot has reached the
triangle symbol. (See figure 12) Once this has occurred,
the filter must be replaced.
Note: The Filter Life Indicator is on top of the
filter cartridge and provides continuous indication
of filter life. The filters are located under the fill
tank. Filter replacement is essential for the product
to perform as represented.
Each P
¯
U
R Water Cooler system processes
approximately 80 gallons/302 liters (40 gallons/
151 liters per filter) which should last the average
family 2-4 months. Time will vary depending on
consumption. Note: If your water dispensing slows significantly, it is a signal
that your filter needs to be changed.
For convenience, it is recommended that both filters are changed at the same
time.
10
11
12