Filter
Top Products
27
Connect the mains cable to the correct terminals for
your electrical supply type (see fig.). Check that the
links are correctly fitted and that the terminal screws
are tight. Secure the mains cable using the cable
clamp.
These appliances are of type X with regard to
protection against over heating of the surrounding
surfaces.
Current Operated Earth Leakage
Breakers
Where the installation is protected by a 30 milliamp
sensitivity residual current device (RCD), the combined
use of your cooker and other domestic appliances may
occasionally cause nuisance tripping. In these
instances the cooker circuit may need to be protected
by fitting 100mA device. This work should be carried
out by a qualified electrician.
Oven Light
Press the oven light switch and check that the light is
working.
NB. The oven light bulb is not included in the
guarantee
Hotplate
Check each burner in turn. Push in tap and turn to the
large flame symbol. Press ignition switch on facia
panel.
Grill
Open the grill compartment door. Turn on the grill
control and check that the grill heats up.
Oven check
The clock must be set to the time of day before the
ovens will work.
Press and hold as above.
At the same time, press - or + until the correct time
shows.
Don’t forget it’s a 24 hour clock.
If you make a mistake or press the wrong button, turn
off the power supply for a minute or two and start
again.
Turn on the oven and check that the oven fan starts to
turn and that the oven starts to heat up. Turn off the
oven.
Fitting the plinth
Loosen the 3 screws along the front bottom edge of the
cooker. Hook the central keyhole over the central
screw. Twist and fit each end keyhole over their
respective screws. Tighten the fixing screws.