Filter
Top Products
5
ISTALLATION
TECHNICAL INSTRUCTIONS FOR THE
INSTALLER
The installation and service procedures given below
may only be carried out by a competent technician.
Failure to install the appliance correctly could be
dangerous and invalidate any warranty or liability
claims. The manufacturer cannot be held
responsible for any damage to persons or property
caused by incorrect installation or use of the
appliance.
1) Preparation
After unpacking the hob, make sure it is complete
and undamaged.
Please keep children away from all packaging
(carton, polystyrene, nails,..).
Make a cutout in the worktop, according to the
dimensions shown in fig. 5; make sure that the
installation will comply with the critical clearance
dimensions (fig. 5 and 6).
2) FIXING
- Screw the fixing brackets to the hob (fig 7).
- Turn the hob over. Carefully fit the seal (“E” in fig.
8) under the hob edge but don’t remove the
protective paper strip. Stick the seal to the hotplate
uniformly, pressing it with your fingers. The ends of
the strip must fit together without overlapping.
- Take the protective paper strip off the seal, place
the hotplate in the opening made in the work top,
and lock it in place with the special screws (“F” in
fig. 9).
IMPORTANT:
The glue used to fix plastic laminate to worktop, has
to be able to withstand 150° C, to avoid
delaminating. This appliance is type Y with regard to
protection against over heating of the surrounding
surfaces. The rear wall, adjacent and surrounding
surfaces must therefore be able to withstand a
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9