Filter
Top Products
14
GB
INSTALLATION
Drilling the Support surface and Fitting the Hood
The Hood can be fi tted directly to the underside of the Wall units (min. 650 mm above the cooker
top) with snap-on side supports, which are set up for a support panel thickness of between 15 mm
and 30 mm.
• Cut a fi tted opening in the bottom surface of the
wall unit, as shown.
• Remove the metal grease fi lters (see par. on
Maintenance).
• Disconnect the fi lter support by turning the
internal handles provided.
• Insert the hood until the side supports snap into
place.
• Lock in position by tightening the screws Vf
from underneath the hood.
375
L2
Vf
Hood Type 54 72
L2 515 695