Filter
Top Products
5
To reduce the power to a cooking zone select the required
zone, as indicated by the red dot in the display. Press the ‘–‘
key to reduce the power required (Fig.2-8).
Note: The ‘–’ key has a repeat function: holding the key
pressed down will reduce the power setting by one level
every 0.3 seconds.
To shutdown a cooking zone:
Make sure the required cooking zone has been selected, as
indicated by the red dot in the display. Reduce the power to
0 (Fig.2-9). After three seconds have elapsed the element will
automatically switch off.
Rapid shutdown:
To switch off a selected zone, press the ‘+’ and ‘–‘ keys
simultaneously: this will immediately switch off that zone
(Fig.2-10).
Note: After a zone has been switched off an ‘H’ may flash in
the display. This is a residual heat indicator that shows that
the cooking zone temperature is above 60°C and may still
cause burns. Once the temperature has dropped to below
60°C the ‘H’ will go out.
To switch off all cooking zones:
All of the cooking zones can be immediately switched off by
pressing the On/Off key. Any ‘hot ‘ zones that were in use will
show an ‘H’ in the display (Fig.2-11).
Preheat Function
This function allows for rapid heating up of the element to
bring the selected cooking zone up to temperature. Once the
zone is at the required cooking temperature the power level
will reduce automatically to the preset level.
To activate the preheat function:
Select the required cooking zone. A red ‘dot’ will illuminate
on the selected display to indicate that the zone has been
selected.
1. Press the ‘–’ key to bring the element up to full power
(Fig.2-12).
2. Press the ‘+’ key to activate the auto function, as
indicated by the ‘A’ (Fig.2-13).
3. Using the ‘–‘ key, set the power to the desired preset
level (Fig.2-14).
When the ‘A’ alternates with the selected power setting the
preheat function is in operation.
To adjust the preheat power level:
Select the cooking zone (make sure the dot is illuminated)
and then press the ‘+’ key to increase the power level. Pressing
the ‘–‘ key after the preheat is underway will interrupt the
operation, switching off the preheat and leaving the cooking
zone operating at one power level lower.
ArtNo.317-0005 60 Rapid switch off
Fig.2-10
ArtNo.317-0015 60 Switching the hob off
Fig.2-11
ArtNo.317-0006 60 Preheat
ArtNo.317-0004 60 Reducing power
Fig.2-9
ArtNo.317-0006 60 Preheat
ArtNo.317-0006 60 Preheat
Fig.2-13
Fig.2-14
Fig.2-12