Filter
Top Products
9
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
You will need the following equipment to complete the hob
installation satisfactorily:
• Gas Pressure tester
• Flexible gas hose
• Multimeter
You will also need the following tools:
1. Electric drill
2. Jigsaw
3. Steel tape measure
4. Cross head screwdriver
5. Pencil
6. Adjustable spanner
7. Sharp knife
Checking the Parts
Check that the appliance is in a good condition after having
removed the packaging. In case of doubt, do not use the
appliance and contact the retailer.
The hob also has 5 individual pan supports
Never leave the packaging materials (cardboard, plastic
bags, polystyrene foam, etc.) within children’s reach since
they could become potential sources of danger.
Positioning the Hob
The hob should be fitted into a work surface, which is at
least 600mm deep. In position, the hob has a maximum
thickness of 50mm from the top of the work surface. The
cut-out dimensions are shown in (Fig.5-1) and the minimum
clearances in (Fig.5-2). The minimum recommended
distances from the hob to nearby surfaces are shown in
(Fig.5-3).
The hob should be fitted into a work surface, which is at least
600mm deep. In position, the hob has a maximum thickness
of 50mm from the top of the work surface, and an overall
thickness of 100mm (120mm max depth including the gas
connector). The cut-out dimensions are shown in (Fig.5-1),
and the minimum clearances in (Fig.5-2).
Note: If installing the hob over a standard cabinet, you may
have to remove part of the cabinet panels to allow the unit to
fit correctly (see Fig.5-1).
It is recommended that there is a minimum air gap of 100cm²
underneath the hob to allow sufficient air circulation to the unit.
It is recommended that the hob be installed in a worktop with a
minimum thickness of 40mm. If installing a built-in oven directly
under the hob then there should be a minimum air gap of 20mm
between the oven and the bottom of the hob.
Failure to maintain a suitable clearance may impair the
performance of the hob.
Any hob hood should be installed in accordance with the
hood manufacturer’s instructions.
Surfaces of furniture and walls at the sides and rear of the hob
should be heat, splash and steam resistant. Certain types of
ArtNo.316-0028 - RGG77 cut-out dimensions
ArtNo.316-0027 RGG77 hob clearances
Fig.5-1
Fig.5-2
Fig.5-3