Filter
Top Products
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
26
ArtNo.320-0004 Oven door keep
Fig.8-9
ArtNo.320-0005 Oven door rubber seal
Fig.8-10
ArtNo.320-0020 Oven back fixing screws
Fig.8-11
ArtNo.320-0003 Oven door latch
�
Fig.8-8
ArtNo.320-0029 - Thermodial
Fig.8-7
14. To Replace the Tall Oven Door Outer Panel
Remove the oven door (see 11). Lay the door face down on a
suitable surface and remove the two screws from the bottom
edge of the door and the two screws from the inside face of
the door.
Remove the outer door panel. Remove the handle by
unscrewing the two screws.
Unscrew the two cross-headed screws holding the door
handle fixing bracket to the door panel. Fit the door handle
bracket and door handle to the new panel.
Fit the panel to the door and reassemble in the reverse order.
15. To Change the Main Oven Door Latch
Remove the outer door panel (see 13). Remove screws ‘B’ that
hold the latch assembly to the inner door panel (Fig.8-8). Fit
the new catch and reassemble in reverse order.
Verify the door operation.
16. To Adjust the Main Oven Door Catch Keep
Open the oven door, and slacken off the locknut at the base
of the keep (Fig.8-9). Screw in or out as required until the
required fit is obtained. Retighten the locking nut.
17. To Replace the Tall oven Magnetic Latch
Remove the control panel (see 1). Remove the plinth
(3 screws) and the central vertical cover (5 screws). Prise the
retaining clip off the magnet unit.
Fit the new unit and retaining clip, and reassemble in reverse
order. Check that the door operates correctly.
18. To Replace an Oven Door Seal
Open the oven door. The seal has small hooks that hold it in
place by locating into holes in the rear door face on the main
oven and oven front face on tall oven. At the corner, pull the
seal diagonally away from the door centre until the hook is
released (Fig.8-10). Proceed to the next hook and release it in
a similar way, and so on.
You can use force if the hooks are stiff, as the old seal will be
discarded.
Carefully lift away the inner back. Reassemble in reverse
order making sure that the four screws and washers are fully
tightened.
19. To Remove an Oven Element Thermal Cut-out
Disconnect from electricity supply.
Pull the cooker forward to gain access to the cover box. Undo
the cover screws and lift clear. The cut-out is located on the
earth plate beside the oven element connections. Disconnect
the cut-out wiring. Undo the fixings that secure the cut-out to
the earth plate and remove. Fit the replacement control and
re-assemble in reverse order.
20. To Remove an Oven Inner Back
Disconnect from electricity supply.
Open the door and remove the shelves. Remove the screws
and washers securing the inner back to the back of the oven
(Fig.8-11). Carefully lift away the inner back. Reassemble in
reverse order making sure that the screws and washers are
fully tightened.