Filter
Top Products
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
27
ArtNo.321-0005 Fan oven element
Fig.8-12
ArtNo.321-0007 - MF oven element 1
�
Fig.8-13
21. To Remove the Fan Oven Element
Disconnect from electricity supply.
Remove the oven inner back (see 20). Remove the two screws
from the top of the element and the one from the bottom of
the element inside the oven (Fig.8-12).
Lift the element out carefully, disconnecting the terminals
connected to the element (noting their positions).
If it is not possible to disconnect the leads in this way, pull the
cooker forward to gain access to the rear.
Remove the screws securing the electric cover to the back
sheet, remove the cover and disconnect the terminals from
the rear.
22. To Replace an Oven Fan
Disconnect from electricity supply.
Pull the cooker forward to gain access to the rear. Remove
the screws securing the electric cover to the back sheet and
remove the cover.
Disconnect the three terminals connected to the fan noting
their position. Remove the oven inner back (see 20). Hold the
fan blade and remove the centre nut (left-hand thread) two
brass washers, fan blade and circlip. Unscrew the fan retaining
nuts and washers (three off each) and lift the fan away from
the rear of the cooker. Fit the new fan and reassemble in
reverse order. Check the operation of the oven.
23. To Remove the Left-hand Oven Bottom and Top
Elements
Disconnect from the electricity supply.
Bottom Element
Pull the cooker forward to access the cover boxes at the rear
of the unit. Remove the fixings that secure the cover and lift it
clear.
Remove the two screws ‘A’ and allow the plate to drop down
(Fig.8-13). Remove the two screws ‘B’ holding the element to
the bottom sheet (Fig.8-14). Undo the terminal connections,
noting their positions. Withdraw the element.
Replace the element and re-assemble parts in reverse order.
Top Element
Open the left-hand oven door and undo the fixings that
secure the heat shield. Remove the top element bracket
fixings and withdraw the element.
Replace the element and re-assemble parts in reverse order.
Check that the oven operates satisfactorily.
24. To Change Oven Light Bulb
Disconnect from electricity supply.
Make sure the oven is cool. Open the oven door and remove
the oven shelves. Remove the grill pan and support from the
grill chamber.
Unscrew the bulb cover by turning anticlockwise. It may be
very stiff (Fig.8-15). Taking care to protect your fingers in case
the bulb should shatter, unscrew the old bulb.
Fit an Edison screw fitting 15W 240V lamp, FOR OVENS. It must
be a special bulb, heat resistant to 300°C (Fig.8-16).
Screw in the new bulb, and then screw back the bulb cover.
Turn on the electricity supply and check that the bulb now
lights.
ArtNo.324-0007 Unscrewing the bulb cover
Fig.8-15
ArtNo.324-0005 Oven light bulb
Fig.8-16
ArtNo.321-0008 - MF oven element 2
�
Fig.8-14