Filter
Top Products
17
Replacing the Light Bulb
Disconnect the appliance from the power supply
before replacing the light bulb.
There is an interior light in the top of the refrigerator section.
Remove the bulb housing cover, by gently pulling the clip
away from its slot (Fig.5-3). Then slide the cover o, removing
the lugs on the cover from the bulb housing.
Change the present light bulb with a new one. The
replacement bulb should not have a greater rating than 15 W.
Replace the light cover and after waiting ve minutes,
reconnect to the mains supply.
When Not in Use
If you are not using the appliance for an extended length
of time, it is recommended that you switch o the electrical
supply, empty any food out, clean the inside of the appliance
and leave the door ajar.
This will save energy, and also prevent a build up of stale
odours inside.
Light bulb
Bulb housing
Bulb cover
Fig.5-3