Filter
Top Products
-9-
Unplug cord from the outlet before cleaning. Allow the steamer to
cool. Never immerse the base, cord and/or plug in water.
•
Empty the JUICE TRAY and WATER RESERVOIR of their contents.
•
Wash the LID, STEAMING BOWLS, RICE BOWL, JUICE TRAY and
REMOVABLE RING in hot, soapy water. Rinse thoroughly and dry all
parts. Or wash on top rack of dishwasher.
•
Pour hot, soapy water into the WATER RESERVOIR. Use a non-
abrasive cleaner or mesh scouring pad to clean the interior. Rinse
with clean, hot water.
•
The LOWER STEAMING BOWL and RICE BOWL can nest inside the
UPPER STEAMING BOWL with the LID on top of all three to save
storage space.
•
After a period of uses, the HEATING ELEMENT surface may discolor or
start to become coated with build up. When cleaning the heating
element follow these steps:
1. Do not cover the BASE with any steamer parts
2. Pour 3 cups of clear vinegar into the WATER RESERVOIR
3. Fill the rest with water, up to the MAX fill line
4. Plug unit in and set the timer for approximately 20 minutes
5. When timer has stopped, unplug the cord from the outlet
6. DO NOT allow solution to boil over or spill onto exterior surfaces
7. Allow unit to cool completely before emptying contents
8. Rinse with cold water and use a non-abrasive scouring pad to scrub
the heating element
NOTE:DO NOT use bleach, abrasive pads/cleaners to clean ANY part of
The FOOD STEAMER.
HOW TO CLEAN YOUR FOOD STEAMER
On / Off
•
When plugging in the Food Steamer, the time “00” will flash on
the display.
•
The cooking time can be set by pressing the COUNT UP/DOWN
BUTTON and it will display in 1 minute intervals. In the adjusting
status, the digits will keep flashing until the operation has started.
•
After setting your desired time, press the ON/OFF BUTTON to start
operation. Then it will start counting down 1 minute at a time.
•
To stop the unit from operating, press the ON/OFF BUTTON and the
time “00” will flash on the display.
•
To adjust the time when operating, press the COUNT UP/DOWN
BUTTON to set. Then the digits begin to flash until the adjustment
has finished and without pressing any button in 5 seconds, the time
display will stop flashing and continue to count down from the time
which had been set.
•
After finishing to count down, the time “00” will flash again on the
display and it will stop operating and a bell will sound.
•
If not enough water is in the RESERVOIR when operating, the time
operation will automatically stop with a continuous tone and the time
“00” will flash on the display. It cannot operate again unless the water
reservoir is refilled.
-8-
DIGITAL TIMER SETTING
COUNT DOWN BUTTON ON/OFF BUTTON
COUNT UP BUTTON
POWER INDICATOR LIGHT
LCD DISPLAY
FSD200.02.NA.OM1 2/10/03 11:09 AM Page 9