Filter
Top Products
English
10
7. FUNCTION / USE AND
PROGRAMMING
INTRODUCTION
The programming software permits the checking of the
following operations:
- handling of 2-3-4 coffee units
- simultaneous function of both coffee and tea units
- cappuccino/milk function
- volumetric check on coffee measures
- timed tea measure check
- simulated measure programming
- filling level check and control
6.5 Replacement of the thermostat to
reduce the coffee dispensing
group temperature.
Remove cup heating bowl (1). Disconnect group thermostat
(2) (Code WGADM1561 – T 103°C) and replace it with
the lower temperature thermostat (Code WGADM1736 –
T 98°C), included in the machine equipment.
- system supervision through alarms
- continuos, delivery time-out and further functions
- serial connection with accounting devices
- 16 X 2 LCD display (not rear-lit) for functional state display.
Important: the last selection made always appears on the
display
6.6 Spouts included in
the supply.
No. 4 spouts are supplied with the
machine to dispense one or two coffees.
The figure (beside) shows the different
distances from the cup-holding tray (H),
depending on the different types of spouts
fitted on the filter holder.
Cod. WGAAS0146/CL
H = 85 mm
Cod. WGA26G0112
H = 95 mm
Cod. WGA6301004010
H = 100 mm
Cod. WGA6001023000
H = 92 mm
H1 = 120 mm
WITHOUT SPOUTS